Learn how to get the most out of your KINEKT Seatpost and customize your ride.
Still stumped? Don’t
worry, we’ll show you.
HEIGHT: Middle of bottom bracket to the top of saddle
REACH: Saddle tip to the center of the bars at the stem
TILT: Tilt of your saddle
Install KINEKT 1 cm higher than normal to allow for sag
Install your saddle to the post
See Rider position A, B, C
Sit in normal riding position
Tighten pre-load bolt (control knob) until saddle no longer rises when unweighted
Reset saddle position using your previously recorded measurements
Use previously recorded height, reach and tilt
Loosen or tighten pre-load bolt/control knob until desired comfort, position, and performance are achieved
Further adjust during subsequent rides to establish settings for various surfaces
Record post settings to repeat favorite set-up on any bike!
Post Material | Diameter | Length | Weight |
---|---|---|---|
Carbon Fiber | 27.2 mm | 330 mm | 471 gm |
Carbon Fiber | 27.2 mm | 380 mm | 487 gm |
Aluminum | 25.4 mm | 350 mm | 525 gm |
Aluminum | 25.4 mm | 420 mm | 525 gm |
Aluminum | 27.2 mm | 350 mm | 525 gm |
Aluminum | 27.2 mm | 420 mm | 563 gm |
Aluminum | 30.9 mm | 350 mm | 508 gm |
Aluminum | 30.9 mm | 420 mm | 533 gm |
Aluminum | 31.6 mm | 350 mm | 529 gm |
Aluminum | 31.6 mm | 420 mm | 566 gm |
Carbon Fiber Posts | Aluminum Posts | |
---|---|---|
Setback | 12 mm (3.1) 25 mm (3.0) | 12 mm (3.1) 25 mm (3.0) |
Travel Range | 0 - 35 mm | 0 - 35 mm |
Primary Material | Carbon Fiber | Aircraft Grade 6061 AL |
Hardware | Stainless Steel | Stainless Steel |
Bushings | Igus | Igus |
Elastomers | Urethane | Urethane |